RELAY(for Windshield Deicer) ON-VEHICLE INSPECTION

PROCEDURE

  1. REMOVE FRONT WIPER DEICER RELAY

    1. Remove the front wiper deicer relay from the engine room relay block.

  2. INSPECT FRONT WIPER DEICER RELAY

    B060778N09

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied to terminals 1 and 2

      10 kΩ or higher

      Battery voltage applied to terminals 1 and 2

      Below 1 Ω

      If the result is not as specified, replace the front wiper deicer relay.

  3. INSTALL FRONT WIPER DEICER RELAY

    1. Install the front wiper deicer relay to the engine room relay block.