SFI SYSTEM(w/o EGR System), Diagnostic DTC:P060A

DTC Code DTC Name
P060A Internal Control Module Monitoring Processor Performance

DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the signal malfunctions below are detected, a DTC is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Memory

P060A

Internal Control Module Monitoring Processor Performance

A CPU reset is performed after one of the following conditions is met (1 trip detection logic):

  • There is an ECM main CPU error.

  • There is an ECM sub CPU error.

  • There is an electronic throttle monitoring CPU error.

ECM

Comes on

DTC stored

CONFIRMATION DRIVING PATTERN

  1. Turn the engine switch off.

  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  3. Connect the cable to the negative (-) battery terminal.

  4. Turn the engine switch on (IG) and wait for 16 seconds or more.

PROCEDURE

  1. CHECK FOR DTC

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the tester on.

    4. Clear DTCs.

      Click here

      Powertrain > Engine and ECT > Clear DTCs

    5. Turn the tester off.

    6. Turn the engine switch off.

    7. Disconnect the intelligent tester.

    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    9. Connect the cable to the negative (-) battery terminal.

    10. Connect the intelligent tester to the DLC3.

    11. Turn the engine switch on (IG) and turn the tester on.

    12. Wait 16 seconds or more.

    13. Enter the following menus: Powertrain / Engine and ECT / DTC.

    14. Check for DTCs.

      Powertrain > Engine and ECT > Trouble Codes

      OK

      P060A is not output.

      Result

      Result

      OK

      NG
    OK

    CHECK FOR INTERMITTENT PROBLEMS

    Click here

    NG

    REPLACE ECM

    Click here