CRUISE CONTROL SYSTEM(for 1WW) Cruise SET Indicator Light Circuit

DTC Code DTC Name
Cruise SET Indicator Light Circuit

DESCRIPTION

  • When the ECM detects a cruise control switch ON signal from the cruise control switch, it sends it to the combination meter assembly through CAN communication. Then the cruise control SET indicator light turns on.

  • The cruise control SET indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

PROCEDURE

  1. PERFORM ACTIVE TEST USING GTS (SET INDICATOR LIGHT)

    1. Select the Active Test, use the GTS to generate a control command, and then check that the combination meter operates (Click here).

      Table 1. Combination Meter

      Tester Display

      Test Part

      Control Range

      Diagnostic Note

      Indicat. SET

      Cruise control SET indicator light

      ON/OFF

      -

      OK

      Indicator light turns on.

    GO TO METER / GAUGE SYSTEM

    (Click here)

  2. READ VALUE USING GTS (-SET SWITCH)

    1. Check the Data List for proper functioning of the SET indicator light (Click here).

      Table 2. Cruise Control

      Tester Display

      Measurement Item/Range

      Normal Condition

      Diagnostic Note

      -SET SW

      -SET switch signal / ON or OFF

      ON: -SET switch on

      OFF: -SET switch off

      -

      OK

      On screen, each item changes between ON and OFF according to above chart.

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    (Click here)

    REPLACE ECM

    (Click here)