SEAT POSITION SENSOR(for Power Seat) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips

PROCEDURE

INSTALL SEAT POSITION AIRBAG SENSOR

*a Adjustment Support

Align the adjustment support and set the seat position airbag sensor into place.
Using a T30 "TORX" socket wrench, temporarily install the seat position airbag sensor with a new "TORX" bolt and nut.
Note
- If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
- When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.
Tech Tips

Temporarily install the seat position airbag sensor so that the sensor does not fall off of the adjustment support.

Insert a 1.3 mm (0.0512 in.) feeler gauge between the seat position airbag sensor and seat rail.

Move the seat position airbag sensor up and down to adjust the clearance between it and the seat rail.
Tech Tips
- Using the adjustment support as an axis, move the seat position vertically to adjust the gap.
- Move the feeler gauge back and forth and adjust the position of the seat position airbag sensor so that a small amount of resistance can be felt.
Using a T30 "TORX" socket wrench, tighten the "TORX" bolt and nut.

Torque:

8.0 N*m { 82 kgf*cm, 71 in.*lbf }
Pull out the feeler gauge.
Check the clearance between the seat position airbag sensor and seat rail.

OK

0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.)
Attach the 2 wire harness clamps.
Connect the connector.
Check that there is no looseness in the installation parts of the seat position airbag sensor.
*1 Tab

Slide the tab of the seat slide position sensor protector between the seat position airbag sensor and seat rail.
Attach the guide to install the seat slide position sensor protector.