TRANSFER CASE OIL SEAL REPLACEMENT


  1. DRAIN TRANSFER OIL

  2. REMOVE LOWER TRANSFER CASE PROTECTOR


    1. A01DWB4

      Remove the 4 bolts and protector.

  3. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

    for TMT made: Click here

    for TSAM made: Click here

  4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY


    1. Using a chisel and hammer, loosen the staked part of the lock nut.

    2. A01DV88E01

      Using SST to hold the companion flange, remove the lock nut.

      SST
      09330-00021
    3. A01DV84E01

      Using SST, remove the companion flange.

      SST
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011 )

  5. REMOVE TRANSFER CASE OIL SEAL


    1. A01DVNDE01

      Using SST, tap out the oil seal.

      SST
      09308-00010

      Note

      Be careful not to damage the oil seal and case front contact surface.

  6. INSTALL TRANSFER CASE OIL SEAL


    1. Coat the lip of a new oil seal with MP grease.

    2. A01E00ZE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the case upper surface.

      SST
      09316-60011   ( 09316-00011 )

  7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

    A01DVEBE01

    1. Apply gear oil to the connecting areas of the companion flange and driven sprocket.

    2. Install the companion flange to the driven sprocket.

    3. Using SST to hold the companion flange, install a new lock nut.

      SST
      09330-00021
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011 )
      Torque:
      118 N*m  { 1,203 kgf*cm, 87 ft.*lbf }
    4. A01E0ZKE01

      Using a chisel and hammer, stake the lock nut to the driven sprocket.

      Note


      • Thoroughly stake the shaft to the lock nut's groove.

      • Be careful not to damage parts around the lock nut.

      • Do not apply excessive force to the shaft.

  8. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

    for TMT made: Click here

    for TSAM made: Click here

  9. INSTALL LOWER TRANSFER CASE PROTECTOR


    1. A01DWB4

      Install the protector with the 4 bolts.

      Torque:
      18 N*m  { 183 kgf*cm, 13 ft.*lbf }

  10. ADD TRANSFER OIL

    Click here