CONDENSER(for 8AR-FTS) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during condenser removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Front television camera assembly

  • Front bumper assembly

  • Radiator grille

 Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system

Click here

PROCEDURE


  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    for HFC-134a (R134a):

    Click here

    for HFO-1234yf (R1234yf):

    Click here

  2. DRAIN COOLANT (for Intercooler)

    Click here

  3. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  4. REMOVE HOOD LOCK CONTROL CABLE COVER (for LHD)

    Click here

  5. REMOVE HOOD LOCK CONTROL CABLE COVER (for RHD)

    Click here

  6. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR

    Click here

  7. REMOVE HOOD LOCK ASSEMBLY

    Click here

  8. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  9. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

    Click here

  10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY


    1. B007ZGZ

      Remove the bolt and disconnect the discharge hose sub-assembly from the cooler condenser assembly.

    2. Remove the O-ring from the discharge hose sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  11. DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY


    1. B007YL1

      Remove the bolt and disconnect the air conditioner tube and accessory assembly from the cooler condenser assembly.

    2. Remove the O-ring from the air conditioner tube and accessory assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  12. DISCONNECT NO. 3 INTERCOOLER COOLING WATER HOSE

    Click here

  13. DISCONNECT NO. 2 INTERCOOLER COOLING WATER HOSE

    Click here

  14. REMOVE WATER BY-PASS HOSE

    Click here

  15. REMOVE COOLER CONDENSER ASSEMBLY WITH INTERCOOLER COOLING RADIATOR ASSEMBLY


    1. B007XYZC02
      B007Z37 Remove in this Direction

      Disengage the 4 claws.

    2. Disengage the 2 guides and remove the cooler condenser assembly with intercooler cooling radiator assembly as shown in the illustration.

      Note

      Do not damage the cooler condenser assembly with intercooler cooling radiator assembly or radiator assembly when removing the cooler condenser assembly with intercooler cooling radiator assembly.

  16. REMOVE COOLER CONDENSER ASSEMBLY


    1. B007ZV8C02
      B007Z37 Remove in this Direction

      Disengage the 4 claws.

    2. Disengage the 2 guides and remove the cooler condenser assembly from the intercooler cooling radiator assembly as shown in the illustration.

      Note

      Do not damage the cooler condenser assembly or intercooler cooling radiator assembly when removing the cooler condenser assembly.