COMBINATION SWITCH INSPECTION

PROCEDURE


  1. REMOVE SATELLITE SWITCH SET

    Click here

  2. INSPECT SATELLITE SWITCH SET (w/ AVS)


    1. B006E36C05
      *a

      Component without harness connected

      (Satellite Switch Set)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G49-6 (ECU) - G49-7 (GND) Satellite switch set knob turned and held at Comf/Eco position Below 50 Ω
      G49-6 (ECU) - G49-7 (GND) Satellite switch set knob not turned to Comf/Eco position 10 kΩ or higher

      If the result is not as specified, replace the satellite switch set.

    2. Apply battery voltage between the terminals of the satellite switch set, and check the illumination condition of the satellite switch set.

      Standard
      Tester Connection Specified Condition

      Battery positive (+) → G49-1 (ILL+)

      Battery negative (-) → G49-8 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the satellite switch set.

  3. INSPECT SATELLITE SWITCH SET (w/o AVS)


    1. B006E36C05
      *a

      Component without harness connected

      (Satellite Switch Set)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G49-6 (ECU) - G49-7 (GND) Satellite switch set knob turned and held at Eco position Below 50 Ω
      G49-6 (ECU) - G49-7 (GND) Satellite switch set knob not turned to Eco position 10 kΩ or higher

      If the result is not as specified, replace the satellite switch set.

    2. Apply battery voltage between the terminals of the satellite switch set, and check the illumination condition of the satellite switch set.

      Standard
      Tester Connection Specified Condition

      Battery positive (+) → G49-1 (ILL+)

      Battery negative (-) → G49-8 (ILL-)

      		 Illuminates

      If the result is not as specified, replace the satellite switch set.

  4. INSTALL SATELLITE SWITCH SET

    Click here