DRIVING SUPPORT ECU INSTALLATION

PROCEDURE


  1. INSTALL DRIVING SUPPORT ECU ASSEMBLY

    Note

    Do not use a driving support ECU if it has been dropped or has been subjected to any strong impact.


    1. B006A2JC01
      *a Wire Harness Clamp
      *b Hook
      B006DHE Install in this Direction

      Install the driving support ECU in the direction of the arrow shown in the illustration and attach the hook.

      Note

      Do not use a driving support ECU if it has been dropped or has been subjected to any strong impact.


      1. Attach the wire harness clamp.

    2. Install the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Attach the wire harness clamp.

    4. B006GKXC01
      B006DHE Install in this Direction

      Attach the clip as shown in the illustration to install the connector holder.

    5. B006EOZ

      Connect the connector.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  4. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

  5. INSTALL COWL SIDE TRIM BOARD LH

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    for 8GR-FKS:

    Click here

    for V35A-FTS:

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here