FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE

  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  4. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  5. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  6. REMOVE V-RIBBED BELT

    Click here

  7. REMOVE CRANKSHAFT PULLEY

    1. A200710E01

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      09213-58014

      91551-80840

      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      09213-54015

      09330-00021

      Table 1. Text in Illustration

      *1

      Hold

      *2

      Turn
      Tip:

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A200711E01

      Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

      09950-50013

      09951-05010

      09952-05010

      09953-05020

      09954-05021

      Table 2. Text in Illustration

      *1

      Hold

      *2

      Turn
      Tip:

      Apply lubricant to the threads and end of SST.

  8. REMOVE TIMING CHAIN COVER OIL SEAL

    1. A200713E01

      Using a screwdriver, pry out the oil seal.

      Table 3. Text in Illustration

      *1

      Protective Tape
      Tip:

      Tape the screwdriver tip before use.

      Note:

      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.