PANORAMIC VIEW MONITOR SYSTEM

CAUTION / NOTICE / HINT

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result

   Proceed to
   NEXT

   NEXT

2. INSPECT BATTERY VOLTAGE

   1. Measure the battery voltage with the engine switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

   Result

   Proceed to
   NEXT

   NEXT

3. CHECK VEHICLE TYPE

   Result

   Result	Proceed to
   w/ Audio and Visual System (for Radio and Display Type)	A
   w/ Navigation System	B

   B

   CHECK NAVIGATION SYSTEMClick here

   A

4. CHECK AUDIO AND VISUAL SYSTEM

   1. Refer to the audio and visual system.

      Click here

      OK

      Audio and visual system is normal.

   Result

   Proceed to
   OK
   NG

   NG

   GO TO AUDIO AND VISUAL SYSTEM

   Click here

   OK

5. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

   1. Use the GTS to check if the CAN communication system is functioning normally.

      for LHD:

      Click here

      for RHD:

      Click here

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

   B

   GO TO CAN COMMUNICATION SYSTEM

   for LHD:

   Click here

   for RHD:

   Click here

   A

6. CHECK FOR DTC*

   1. Check for DTCs and note any codes that are output.

      Click here

      Chassis > Panoramic View Monitor > Trouble Codes

   2. Clear the DTCs.

      Click here

      Chassis > Panoramic View Monitor > Clear DTCs

   3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Chassis > Panoramic View Monitor > Trouble Codes

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

   B

   ADJUST, REPAIR OR REPLACEClick here

   A

7. PROBLEM SYMPTOMS TABLE

   1. Refer to the Problem Symptoms Table.

      Click here

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   B

   ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

   A

8. OVERALL ANALYSIS AND TROUBLESHOOTING*

   1. Data List / Active Test

      Click here

   2. Terminals of ECU

      Click here

   Result

   Proceed to
   NEXT

   NEXT

9. ADJUST, REPAIR OR REPLACE

   Result

   Proceed to
   NEXT

   NEXT

10. CONFIRMATION TEST

    Result

    Proceed to
    NEXT

    NEXT

    END

11. CHECK NAVIGATION SYSTEM

    1. Refer to the navigation system.

       Click here

       OK

       Navigation system is normal.

    Result

    Proceed to
    OK
    NG

    OK

    CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*Click here

    NG

    GO TO NAVIGATION SYSTEM

    Click here