DOOR CONTROL BATTERY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the door control battery removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure	Necessary Procedures	Effects / Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)	Stop and start system	Click here
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Pre-collision system	Click here

Tech Tips

Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.

PROCEDURE

PRECAUTION (w/ Airbag System)

CAUTION:

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click here

for Type B:

Click here

for Type C:

Click here

Note

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click here
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Airbag System)
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Click here
REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Click here
REMOVE DOOR CONTROL BATTERY
1. Bolt
  
  Connector
  
  Remove the 2 bolts.
2. Detach the hook and remove the door control battery.
3. Disconnect the connector.

	Bolt
	Connector