FUEL SUPPLY PUMP INSTALLATION

CAUTION / NOTICE / HINT

Note:

  • Do not remove SST (A) from the timing chain cover plate until all repair work has been completed.

  • Always be sure to check the tightening torque.

  • If the pressure lines are leaking after installation, they must be replaced.

  • Do not overtighten the pressure lines.

PROCEDURE

  1. INSTALL FUEL SUPPLY PUMP ASSEMBLY

    Tip:

    Perform "Supply Pump Learning Value Reset" after replacing the fuel supply pump assembly.

    Click here

    1. Install the fuel quantity control valve with the 2 bolts.

      Tip:

      Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.

    2. A316278C01

      *1

      Injection Pump Drive Gear

      To insert the fuel supply pump assembly shaft in the injection pump drive gear, it may be necessary to turn the fuel supply pump assembly several degrees so that the spline indicated by the arrow in the illustration and the groove in the fuel supply pump assembly shaft are aligned. Then rotate the fuel supply pump assembly back to the position where the screw can be installed.

    3. Install the fuel supply pump assembly to the cylinder block.

      Note:

      Do not damage the shaft, especially the taper.

      A316279
      Tip:

      When installing a new fuel supply pump assembly, adjust the fuel supply pump assembly and injection pump drive gear alignment by turning the fuel supply pump assembly 45° clockwise (top view).

    4. A316277N01

      Tighten the central bolt connection between the fuel supply pump assembly and injection pump drive gear.

      65 N*m

      663 kgf*cm

      48 ft.*lbf

    5. Install the 2 bolts to the fuel supply pump assembly.

      19 N*m

      194 kgf*cm

      14 ft.*lbf

    6. A316275N01

      Temporarily install the fuel supply pump assembly support with the 4 bolts by hand in the order shown in the illustration.

    7. A316275N03

      Tighten the 4 bolts in the order shown in the illustration.

      19 N*m

      194 kgf*cm

      14 ft.*lbf

    8. A316274N01

      Install SST (B) to SST (A), and then remove both SST (A) and SST (B).

      SST

      PZ4TB-04967-25

    9. Apply a light coat of engine oil to a new O-ring, and install it to the sealing cap.

    10. Install the sealing cap to the timing chain cover plate.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

    11. Install 2 new clamps to the fuel feed line hose and fuel return line hose.

    12. Connect the fuel feed line hose and fuel return line hose to the fuel supply pump assembly and tighten the 2 clamps.

      3.0 N*m

      31 kgf*cm

      27 in.*lbf

    13. Connect the fuel quantity control valve connector.

  2. INSTALL FUEL INLET PIPE SUB-ASSEMBLY

    Click here

  3. INSPECT FOR FUEL LEAK

    Click here

  4. PERFORM INITIALIZATION

    1. Perform "Supply Pump Learning Value Reset" after replacing the fuel supply pump assembly.

      Click here