ДАТЧИК ПОЛОЖЕНИЯ КОЛЕНЧАТОГО ВАЛА УСТАНОВКА


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A01DXF5E04

      Apply a light coat of engine oil to the O-ring of the sensor.

    2. Install the sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    3. Install the connector to the connector bracket.

    4. Attach the harness clamp.

    5. Connect the sensor connector.

  2. INSTALL NO. 1 COMPRESSOR MOUNTING BRACKET

    Note

    Install the No. 1 compressor mounting bracket exactly as described in the procedures below to properly secure and prevent damage to the fan and generator V belt.


    1. A01DWJG

      Temporarily install the No. 1 compressor mounting bracket with the 3 bolts.

      Tech Tips

      Temporarily install the No. 1 compressor mounting bracket with the 3 bolts so that the bracket can be moved by hand.

    2. Push the No. 1 compressor mounting bracket toward the cylinder block as shown in the illustration and tighten the bolt B.

      A01E2C4E01
      Torque:
      45 N*m  { 459 kgf*cm, 33 ft.*lbf, for bolt B }

      Tech Tips

      Make sure there is no clearance between the cylinder block and No. 1 compressor mounting bracket as shown in the illustration.

    3. A01E2A8E01

      Uniformly tighten the 4 bolts in the order shown in the illustration.

      Torque:
      45 N*m  { 459 kgf*cm, 33 ft.*lbf, for bolt A }
      24.5 N*m  { 250 kgf*cm, 18 ft.*lbf, for bolt C }

  3. INSTALL COOLER COMPRESSOR ASSEMBLY

    A01DXCDE02

    1. Temporarily install the compressor with the bolt labeled A.

    2. Install the compressor completely by tightening the 4 bolts in the order shown in the illustration.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      In order to prevent misalignment, which causes belt rattle, tightening of the bolts must be performed in the order shown.

    3. Connect the compressor connector.

    4. A01E33NE02

      Install the suction hose with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. INSTALL DRIVE BELT


    1. A01DV06E02

      Install the drive belt to the pulleys except the drive belt tensioner pulley.

    2. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and then install the drive belt to the tensioner pulley.

      Note


      • The backside of the drive belt should face the tensioner pulley.

      • Check that the drive belt is properly set to each pulley.

    3. A01DY7GE01

      After a new belt has been installed, check that the tensioner indicator mark is within range A shown in the illustration.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.