СТАРТЕР (для моделей мощностью 1,7 кВт) УСТАНОВКА


  1. INSTALL STARTER ASSEMBLY


    1. A01DZL4E03

      Install the starter with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Install the starter wire to terminal 30 with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Attach the terminal cap.

    4. Connect the starter connector.

  2. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

    A01DYZ6

    1. Coat a new O-ring with ATF, and install it to the oil filler tube.

    2. Install the oil filler tube to the transmission with the 2 bolts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    3. Install the oil dipstick.

  3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

    A01DVK3E02

    1. Install the clutch release cylinder with the 2 bolts.

      Torque:
      12 N*m  { 120 kgf*cm, 9 ft.*lbf }

  4. INSTALL FRONT FENDER SEAL


    1. Install the front fender seal with the 5 clips.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.