TIRE PRESSURE WARNING RESET SWITCH INSPECTION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the LHD and RHD vehicles.

PROCEDURE


  1. INSPECT TIRE PRESSURE WARNING RESET SWITCH


    1. A004KBHE01
      Text in Illustration
      *a

      Component without harness connected

      (Tire Pressure Warning Reset Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      6 - 3 Pushed (ON) Below 1 Ω
      6 - 3 Not pushed (OFF) 10 kΩ or higher

    2. Apply battery voltage between the terminals of the light, and check the operation of the light.

      OK
      Tester Condition Specified Condition

      Battery positive (+) → terminal 5

      Battery negative (-) → terminal 4

      		 LED illuminate

      If the result is not as specified, replace the tire pressure warning reset switch.