SFI SYSTEM(w/o Canister Pump Module) Starter Signal Circuit

DESCRIPTION

While the engine is being cranked, current flows from terminal STA2 of the engine stop and start ECU to terminal STA of the ECM (STA signal).

WIRING DIAGRAM

Refer to DTC P061512.

Click here

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK WHETHER ENGINE CAN BE CRANKED


    1. Check if the engine can be cranked.

      Result
      Result Proceed to
      Engine cannot be cranked A
      Engine can be cranked B

    B

    READ VALUE USING GTS (STARTER SW) Click here

    A

  2. READ VALUE USING GTS (STARTER SW)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Starter SW.


      Powertrain > Engine > Data List
      Tester Display
      Starter SW

    5. Check the value displayed on the GTS when the engine switch is turned on (IG) and the engine is started.

      OK
      Condition GTS Display (Starter SW)
      Engine switch on (IG) OFF
      Engine started ON
      Result
      Proceed to
      OK
      NG

    OK

    GO TO STOP AND START SYSTEM (STARTER SIGNAL CIRCUIT) Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (ECM - STOP AND START ECU - ST NO. 2 RELAY)


    1. Disconnect the ECM connector.

    2. Disconnect the engine stop and start ECM connector.

    3. Remove the ST NO. 2 relay from the No. 2 engine room relay block.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A95-16 (STA) - A34-23 (STA2) Always Below 1 Ω
      A95-16 (STA) or A34-23 (STA2) or 2 (ST NO. 2 relay) - Body ground and other terminals Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    GO TO STOP AND START SYSTEM (STARTER SIGNAL CIRCUIT) Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  4. READ VALUE USING GTS (STARTER SW)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Starter SW.


      Powertrain > Engine > Data List
      Tester Display
      Starter SW

    5. Check the value displayed on the GTS when the engine switch is turned on (IG) and the engine is started.

      OK
      Condition GTS Display (Starter SW)
      Engine switch on (IG) OFF
      Engine started ON
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR (ST NO. 2 RELAY - ECM)