SUSPENSION CONTROL ECU(for Air Suspension) INSTALLATION

PROCEDURE


  1. INSTALL SUSPENSION CONTROL ECU


    1. B006DB1

      Install the suspension control ECU with the 2 nuts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • Avoid any impact to the suspension control ECU.

      • Do not drop the suspension control ECU. If it is dropped, replace it with a new one.

    2. Connect the 2 connectors.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. INSTALL SIDE TRIM BOX

    Click here

  4. INSTALL REAR FLOOR FINISH PLATE

    Click here

  5. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  6. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  7. INSTALL ROPE HOOK ASSEMBLY

    Click here

  8. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

    Click here

  9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  10. CHECK VEHICLE HEIGHT

    Note

    If the height control sensor link is removed, check the vehicle height.


    1. Change the height control switch from the "NORM" position to the "HIGH" position and back to the "NORM" position again.

    2. Measure the vehicle height.

      Click here

  11. ADJUST VEHICLE HEIGHT

    Click here

    Note

    If the height control sensor has been replaced, be sure to adjust the vehicle height.

  12. ADJUST HEADLIGHT ASSEMBLY

    Click here