COMBINATION METER INSTALLATION

PROCEDURE

1. INSTALL COMBINATION METER SUB-ASSEMBLY

   
   

   1. Connect each connector.

   2. Engage the clamp.

   3. 

      Move the combination meter sub-assembly as shown in the illustration.

   4. Install the combination meter sub-assembly with the 4 screws.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

3. INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

   Click here

4. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

5. INSTALL CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

6. INSTALL INSTRUMENT PANEL BOX ASSEMBLY

   Click here

7. INSTALL INTEGRATION CONTROL AND PANEL

   Click here

8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

9. INSTALL DECK FLOOR BOX RH

   Click here

10. INSTALL REAR DECK FLOOR BOX

    Click here

11. INSTALL NO. 1 DECK BOARD

    Click here

12. INSTALL NO. 2 DECK BOARD

    Click here

13. INSTALL DECK BOARD ASSEMBLY

    Click here