SPIRAL CABLE INSTALLATION

PROCEDURE

1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   1. Attach the 3 claws to install the spiral cable.

      CAUTION:

      When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

   2. Connect the connectors to the spiral cable.

      Note:

      When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL UPPER STEERING COLUMN COVER

   Click here

3. INSTALL LOWER STEERING COLUMN COVER

   Click here

4. ADJUST SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

   1. Turn the engine switch off.

   2. Disconnect the cable from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   3. Check the check window shown in the illustration.

      Tip:

      When the spiral with sensor cable sub-assembly is centered, the connector is at the top and the conditions below can be checked.

      • w/o Steering Heater:

        With the steering wheel straight ahead, align the matchmarks to check the colored roller from the check window.

      • w/ Steering Heater:

        With the steering wheel straight ahead, align the matchmarks to check the U-turn point of the cable from the check window.

      

      *A	w/o Steering Heater	*B	w/ Steering Heater
      *C	for Type A	*D	for Type B
      *a	Check Window	*b	Matchmark
      	Colored Roller		U-turn Point

   4. If the spiral with sensor cable sub-assembly is not centered, center it.

   5. 

      Rotate the spiral with sensor cable sub-assembly counterclockwise slowly by hand until it stops.

      Note:

      Do not turn the spiral with sensor cable sub-assembly using the airbag wire harness.

   6. Rotate the spiral with sensor cable sub-assembly 2.5 times clockwise from the lock position to align the matchmarks and check the check window.

      Tip:

      • The spiral with sensor cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.

      • When the spiral with sensor cable sub-assembly is centered, the connector is at the top and the conditions below can be checked.

      • w/o Steering Heater:

        With the steering wheel straight ahead, align the matchmarks to check the colored roller from the check window.

      • w/ Steering Heater:

        With the steering wheel straight ahead, align the matchmarks to check the U-turn point of the cable from the check window.

      

      *A	w/o Steering Heater	*B	w/ Steering Heater
      *C	for Type A	*D	for Type B
      *a	Check Window	*b	Matchmark
      	Colored Roller		U-turn Point

      If the spiral with sensor cable sub-assembly cannot be centered, it is possible that the spiral with sensor cable sub-assembly is broken. Replace the spiral with sensor cable sub-assembly with a new one.

5. INSTALL STEERING WHEEL ASSEMBLY

   1. Install the steering wheel assembly (Click here).