OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL OIL PRESSURE SENSOR

    1. Apply Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.

      Note:

      If reusing the oil pressure sensor, check that the O-ring is not damaged.

    2. C328304C01

      *a

      SST Fulcrum Length

      *b

      Torque Wrench Fulcrum Length

      Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

      09326-22011

      Specified tightening torque

      20.6 N*m

      210 kgf*cm

      15 ft.*lbf

      Tip:

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click hereClick hereClick here

      • When using SST (fulcrum length of 50 mm (1.9685 in.)) + torque wrench (fulcrum length of 180 mm (7.0866 in.)): 16.1 N*m (164 kgf*cm, 12 ft.*lbf)

    3. Connect the oil pressure sensor connector.

  2. INSTALL REAR ENGINE UNDER COVER LH

    Click hereClick hereClick here

  3. INSTALL FRONT WHEEL LH

    Click hereClick here

  4. RESET MEMORY

    Click hereClick here