ROOM LIGHT INSPECTION

PROCEDURE


  1. INSPECT SPOT LIGHT ASSEMBLY


    1. Inspect the rear dome light.


      1. A01RBAFC02
        *a

        Component without harness connected

        (Spot Light Assembly)

        Apply battery voltage to the connector and check that the rear map light comes on.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → 2 (B)

        Battery negative (-) → 4 (E)

        		 Rear dome light switch on Rear dome light comes on

        Battery positive (+) → 2 (B)

        Battery negative (-) → 3 (CTY)

        		 Rear dome light switch off Rear dome light comes on

        If the result is not as specified, replace the spot light assembly.

    2. Inspect the switch illumination.


      1. Apply battery voltage to the connector and check that the switch illumination comes on.

        OK
        Measurement Condition Condition Specified Condition

        Battery positive (+) → 5 (ILLB)

        Battery negative (-) → 4 (E)

        		 Always Switch illumination comes on

        If the result is not as specified, replace the spot light assembly.