TRANSMISSION WIRE INSPECTION

PROCEDURE


  1. INSPECT ATF TEMPERATURE SENSOR (TRANSMISSION WIRE)


    1. A004IC2E93
      Text in Illustration
      *a

      Component without harness connected

      (ATF Temperature Sensor (Transmission Wire))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (E2) - 9 (OIL) Always 79 Ω to 156 kΩ
      1 (E2) - Body ground Always 10 kΩ or higher
      9 (OIL) - Body ground Always 10 kΩ or higher

      Tech Tips

      If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

      Standard Resistance
      ATF Temperature Specified Condition
      10°C (50°F) 5 to 8 kΩ
      25°C (77°F) 2.5 to 4.5 kΩ
      110°C (230°F) 0.22 to 0.28 kΩ

      If the result is not as specified, replace the ATF temperature sensor (transmission wire).