MONOLITHIC CONVERTER COMPONENTS
ILLUSTRATION
*A |
for LHD |
- |
- |
*1 |
NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL |
*2 |
OUTER COWL TOP PANEL |
*3 |
WATER GUARD PLATE LH |
- |
- |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
for RHD |
- |
- |
*1 |
NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL |
*2 |
OUTER COWL TOP PANEL |
*3 |
WATER GUARD PLATE LH |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
for LHD |
*B |
for RHD |
*1 |
AIR CLEANER CAP WITH AIR CLEANER HOSE |
*2 |
ENGINE WIRE |
*3 |
NO. 1 HOSE TO HOSE TUBE |
*4 |
CHECK VALVE TO CONNECTOR TUBE HOSE |
*5 |
UNION TO CONNECTOR TUBE HOSE |
*6 |
WIRE HARNESS CLAMP BRACKET |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*1 |
AIR TUBE ASSEMBLY |
*2 |
INLET NO. 1 AIR DUCT SUB-ASSEMBLY |
*3 |
VACUUM REGULATING VALVE ASSEMBLY |
*4 |
VENTILATION EJECTOR |
*5 |
VENTILATION HOSE |
*6 |
NO. 4 VENTILATION HOSE |
*7 |
NO. 2 INTERCOOLER WATER HOSE |
*8 |
NO. 3 INTERCOOLER WATER HOSE |
*9 |
NO. 1 VACUUM TRANSMITTING HOSE ASSEMBLY |
*10 |
NO. 2 VACUUM TRANSMITTING HOSE ASSEMBLY |
*11 |
NO. 3 VACUUM TRANSMITTING HOSE ASSEMBLY |
*12 |
NO. 2 VACUUM SWITCHING VALVE BRACKET |
*13 |
NO. 1 ENGINE COVER |
*14 |
O-RING |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
Type A |
*B |
Type B |
*1 |
FRONT CENTER FLOOR BRACE SUB-ASSEMBLY |
*2 |
FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) |
*3 |
COMPRESSION SPRING |
*4 |
EXHAUST PIPE SUPPORT |
*5 |
EXHAUST PIPE GASKET |
*6 |
FRONT NO. 1 FLOOR HEAT INSULATOR |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*1 |
EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst) |
*2 |
OUTLET TURBINE ELBOW GASKET |
*3 |
NO. 2 TURBO INSULATOR |
*4 |
DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY |
*5 |
MANIFOLD SUPPORT BRACKET |
*6 |
NO. 1 MANIFOLD CONVERTER INSULATOR |
*7 |
AIR FUEL RATIO SENSOR |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |