REVOLUTION SENSOR INSPECTION

PROCEDURE

  1. INSPECT TRANSMISSION REVOLUTION SENSOR (NIN)

    1. C221276E02

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      1 (NIN-) - 2 (NIN +)

      20°C (68°F)

      560 to 680 Ω

      • If the result is not as specified, replace the transmission revolution sensor (NIN).

      Table 1. Text in Illustration

      *a

      Component without harness connected

      (Transmission Revolution Sensor (NIN))

  2. INSPECT TRANSMISSION REVOLUTION SENSOR (NOUT)

    1. Wave a magnetic object left and right in front of the transmission revolution sensor (NOUT) tip (5 mm (0.197 in.) or less) to change the high/low signals while measuring the current.

      C154686E19
      Table 2. Text in Illustration

      *1

      Battery

      -

      -

      *a

      Component without harness connected

      (Transmission Revolution Sensor (NOUT))

      *b

      Magnet

      *c

      5 mm (0.197 in.) or less

      *d

      Ammeter
      Note:

      Make sure to wave the magnetic object during the inspection. Current will not change without waving the magnetic object as indicated by the arrow in the illustration.

    2. Measure the current according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      1 (NOTO) - 2 (NOTB)

      Low signal

      4 to 8 mA

      High signal

      12 to 16 mA

      • If the result is not as specified, replace the transmission revolution sensor (NOUT).