MAP LIGHT BULB REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • When replacing the map light bulb with a new one, if the bulb socket is blue, use a 5 W bulb.

  • When replacing the map light bulb with a new one, if the bulb socket is black, use an 8 W bulb.

PROCEDURE


  1. REMOVE MAP LIGHT ASSEMBLY


    1. A01SHRTC01
      B0068AS Insert Moulding Remover D Here
      B0069FO Remove in this Direction

      Insert moulding remover D at the position shown in the illustration and pull as shown to detach the clip.

    2. A01SI86C01
      B0068AS Place Hands Here
      B0069FO Remove in this Direction

      Place your hands in the gap created during the above procedure and pull down to detach the clip as shown in the illustration.

    3. Disconnect the connector and remove the map light assembly.

  2. REMOVE BULB ASSEMBLY


    1. A01SG7PC01
      B0069FO Remove in this Direction

      Turn the 2 bulb assemblies as shown in the illustration to remove them from the map light.

  3. REMOVE MAP LIGHT BULB


    1. A01SHEKC01
      B0069FO Remove in this Direction

      Remove the map light bulb.

  4. INSTALL MAP LIGHT BULB


    1. A01SHNOC01
      B0069FO Install in this Direction

      Install the map light bulb.

  5. INSTALL BULB ASSEMBLY


    1. A01SHDJC01
      B0069FO Install in this Direction

      Turn the 2 bulb assemblies as shown in the illustration to install them to the map light.

  6. INSTALL MAP LIGHT ASSEMBLY


    1. A01SG3QC01
      B0069FO Install in this Direction

      Connect the connector.

    2. Attach the clip to install the map light assembly as shown in the illustration.