REAR BUMPER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click here

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT COVER LH

    Click here

  2. REMOVE REAR COMBINATION LIGHT COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE REAR BUMPER ASSEMBLY


    1. B004M3SC01
      B0087TV Protective Tape

      Apply protective tape around the rear bumper assembly as shown in the illustration.

    2. B004M7W

      Remove the 2 screws.

    3. B004HKS

      Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B004LAY

      for Single Type:


      1. Remove the 9 clips.

    5. B004LWQ

      for Dual Type:


      1. Remove the 8 clips.

    6. B004MMEC01
      B00847Z Remove in this Direction

      Disengage the 6 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. B004MYIC01
      B00847Z Remove in this Direction

      Disengage the 4 claws and 2 guides to remove the rear bumper assembly as shown in the illustration.

    8. w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the connector to remove the rear bumper assembly.