REAR COIL SPRING INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR UPPER COIL SPRING INSULATOR LH

    C276119C01

    *a

    10 mm or less

    1. Install the rear upper coil spring insulator to the rear coil spring.

      Note:

      Install the rear upper coil insulator so that the distance between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.

  2. INSTALL REAR LOWER COIL SPRING INSULATOR LH

    1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm.

  3. INSTALL REAR COIL SPRING LH

    1. C266194C02

      *a

      Identification Mark

      Install the rear coil spring to the rear No. 2 suspension arm.

      Note:

      Install the rear coil spring so that the identification marks are positioned as shown in the illustration.

    2. C267389

      Using a jack and wooden block, raise the vehicle gradually to install the rear No. 2 suspension arm to the rear axle carrier. Then temporarily install the bolt.

  4. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    Click here

  5. STABILIZE SUSPENSION

    Click here

  6. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    1. C266199

      Tighten the bolts of the suspension arm.

      90 N*m

      918 kgf*cm

      66 ft.*lbf

      Note:

      Since a stopper nut is used, tighten the bolt.

  7. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Click here

  8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)

    Click here

  9. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click hereClick hereClick here