SHIFT LEVER INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

   1. Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.

   2. 

      Fully tighten the 4 bolts in the order shown in the illustration.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

   3. w/o Smart Entry and Start System:

      1. Engage the 4 clamps to connect the wire harness to the transmission floor shift assembly.

      2. Connect the transmission control switch connector.

      3. Connect the shift lock control ECU connector.

   4. w/ Smart Entry and Start System:

      1. Engage the 4 clamps to connect the wire harness to the transmission floor shift assembly.

      2. Connect the transmission control switch connector.

      3. Connect the shift lock control ECU connector.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

   1. Turn the nut of the transmission control cable assembly approximately 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

      

      *a	Stopper	*b	Nut
      *c	Push in	*d	Turn approximately 180°

      Tip:

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

   2. Connect the transmission control cable assembly to the transmission floor shift assembly. Check that the spring is positioned at (A) and push in the stopper.

      

      *1	Transmission Floor Shift Assembly	-	-
      *a	Stopper	*b	Spring
      *c	Nut	*d	Push in

      Note:

      • If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

      • Make sure that the transmission control cable assembly is securely locked.

   3. 

      Confirm that the shift lever is in N, and then install the end of the transmission control cable assembly to the transmission floor shift assembly.

      Note:

      • Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.

      • Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.

3. INSTALL REAR CONSOLE BOX ASSEMBLY

   Click here

4. INSTALL SHIFT LOCK RELEASE BUTTON COVER

   1. 

      *a

      Groove

      Engage the 2 claws to install the shift lock release button cover to the position indicator housing assembly.

      Note:

      Install the shift lock release button cover with its groove facing the rear of the vehicle.

5. INSPECT SHIFT LEVER POSITION

   Click here

6. ADJUST SHIFT LEVER POSITION

   Click here