STARTER REASSEMBLY

PROCEDURE

  1. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

    1. A258318

      Apply high-temperature grease to the areas of the starter pinion drive lever indicated in the illustration.

    2. Install the starter pinion drive lever and rubber seal to the starter center bearing clutch.

    3. Install the starter center bearing clutch together with the starter pinion drive lever and rubber seal to the starter drive housing.

    4. A258319

      Apply high-temperature grease to the planetary gears and pins of the starter center bearing clutch as shown in the illustration.

    5. Install the 3 planetary gears.

  2. INSTALL STARTER ARMATURE ASSEMBLY

    1. Install the starter armature to the starter yoke.

      Note:

      The magnet of the starter yoke may attract the starter armature when the starter commutator end frame is installed causing the magnet to break.

  3. INSTALL STARTER BRUSH HOLDER ASSEMBLY

    1. A215977

      Push out the 4 brushes from the brush holder so that they are held in place by the springs as shown in the illustration.

    2. A215968

      Install the brush holder to the starter armature and push in the 4 brushes.

      Note:

      Check that the positive (+) lead wires are not grounded.

    3. A272690C01

      *1

      Grommet

      *2

      Negative Side

      *3

      Positive Side

      Insert the grommet between the positive side and negative side.

  4. INSTALL STARTER YOKE ASSEMBLY

    1. A258320C01

      *1

      Key A

      *2

      Key B

      Install the starter armature plate to the starter yoke.

      Note:

      Install the starter armature plate so that the keyway is positioned between key A and key B.

    2. Install the starter commutator end frame with the 2 screws.

      1.5 N*m

      15 kgf*cm

      13 in.*lbf

    3. A258321C01

      *1

      Keyway

      *2

      Key

      Align the key of the starter yoke with the keyway located on the starter drive housing.

    4. Using a T25 "TORX" socket wrench, install the 2 bolts.

      6.0 N*m

      61 kgf*cm

      53 in.*lbf

  5. INSTALL MAGNET STARTER SWITCH ASSEMBLY

    1. A258322C01

      *a

      High-temperature grease

      Apply high-temperature grease to the plunger hook.

    2. Hang the plunger of the magnet starter switch onto the drive lever from the upper side.

    3. Install the magnet starter switch with the 2 nuts.

      7.5 N*m

      76 kgf*cm

      66 in.*lbf

    4. Connect the lead wire to the magnet starter switch with the nut.

      10 N*m

      102 kgf*cm

      7 ft.*lbf