STARTER REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click hereClick here

  5. REMOVE FLYWHEEL HOUSING SIDE COVER

    1. A288535

      Disengage the claw by pulling the flywheel housing side cover outward and remove the flywheel housing side cover.

  6. REMOVE STARTER ASSEMBLY

    1. A242713

      Disengage the 2 clamps.

    2. A242714

      Open the terminal cap.

    3. Remove the nut and disconnect terminal 30.

    4. Disconnect the connector.

    5. A261148

      Remove the 2 bolts and starter assembly.

    6. Remove the bolt and wire harness clamp bracket.