CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

  1. INSTALL CRANKSHAFT POSITION SENSOR

    1. A191152C02

      *1

      O-Ring

      Apply a light coat of engine oil to the O-ring of the sensor.

      Note:

      • When reusing the sensor, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the sensor.

    2. Install the sensor with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

    3. Connect the sensor connector.

  2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click hereClick here

  3. INSTALL COOLER COMPRESSOR ASSEMBLY

    Click here

  4. INSTALL GENERATOR ASSEMBLY

    Click here