GENERATOR(for 100 A Type) INSTALLATION

PROCEDURE

  1. INSTALL GENERATOR ASSEMBLY

    1. Install the wire harness clamp bracket with the bolt.

      7.7 N*m

      79 kgf*cm

      68 in.*lbf

    2. A296609

      Temporarily install the generator with the bolt.

    3. A296608

      Temporarily install the adjusting bar with the 2 bolts.

    4. Install the wire harness to terminal B with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

    5. Install the terminal cap.

    6. Connect the connector and attach the wire harness clamp.

    7. A297357

      Tighten the bolt.

      25 N*m

      255 kgf*cm

      18 ft.*lbf

  2. INSTALL V-RIBBED BELT

    Click here

  3. ADJUST V-RIBBED BELT

    Click here

  4. INSPECT V-RIBBED BELT

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  6. INSTALL NO. 2 CYLINDER HEAD COVER

    Click hereClick here

  7. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER

    Click here