INPUT SHAFT INSPECTION

PROCEDURE

  1. INSPECT INPUT SHAFT

    1. C113554

      Check the input shaft for wear and damage.

    2. Using a dial indicator, measure the input shaft runout.

      Maximum runout

      0.03 mm (0.00118 in.)

      If the runout is more than the maximum, replace the input shaft.

    3. C112446E01

      Using a micrometer, measure the journal diameter at A and B on the input shaft.

      Standard Journal Diameter

      Measured Part

      Specified Condition

      Journal A

      30.008 to 30.020 mm (1.1815 to 1.1818 in.)

      Journal B

      32.002 to 32.018 mm (1.2600 to 1.2605 in.)

      If the diameter is not as specified, replace the input shaft.