PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1626

Steering Angle Sensor Failure

A fail flag is transmitted from the steering angle sensor.

  • Spiral with sensor cable sub-assembly (Steering angle sensor)

  • Parking assist ECU

CAUTION / NOTICE / HINT

Note:

  • When "System initializing" is displayed on the display and navigation module display after the battery terminal disconnected, correct the steering angle neutral point (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

PROCEDURE

  1. REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    1. Replace the spiral with sensor cable sub-assembly.

      Click here

      Result

      Result

      NEXT
    NEXT

  2. CHECK FOR DTC

    1. Clear the DTCs.

      Click here

      Chassis > IPA/Parking Assist Monitor > Clear DTCs

    2. Check for DTCs.

      Click here

      Chassis > IPA/Parking Assist Monitor > Trouble Codes

    Result

    Result

    Proceed to

    DTC C1626 is output

    A

    No DTC is output

    B
    A

    REPLACE PARKING ASSIST ECU

    Click here

    B

    END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY WAS DEFECTIVE)