TELEPHONE ANTENNA CORD REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the telephone antenna cord removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedure	Effect/Inoperative when not Performed	Link
Disconnect cable from negative battery terminal	Memorize steering angle neutral point	Lane departure alert system (w/ Steering Control)	Click here
		Simple intelligent parking assist system*1
		Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
		Pre-collision system
	Initialize back door lock	Power door lock control system	Click here
	Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2	Stop and start system	Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

PROCEDURE

REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Click here
REMOVE ROOF HEADLINING

Click here
REMOVE ANTENNA CORD SUB-ASSEMBLY
1. Disengage the guides to remove the antenna cord sub-assembly.
REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
1. Type A:
  1. Remove the adhesive tape from the roof headlining.
    
    Adhesive Tape Front
  2. Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.
2. Type B:
  1. Remove the adhesive tape from the roof headlining.
    
    Adhesive Tape Front
  2. Disengage the clamp and notch to remove the No. 2 antenna cord sub-assembly from the roof headlining.
REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
1. *a Clamp
  
  *b Guide
  
  Disconnect the connector.
2. Remove the bolt.
3. Using a clip remover, disengage the clamps and guide to remove the No. 3 antenna cord sub-assembly.

*a	Clamp
*b	Guide