ECD SYSTEM, Diagnostic DTC:P0606,P060A,P060B and P1607

DTC Code DTC Name
P0606 ECM / PCM Processor
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance
P1607 Cruise Control Input Processor

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

P0606

ECM / PCM Processor

ECM internal error continues for 1 second (1 trip detection logic).

ECM

Comes on

DTC stored

P060A

Internal Control Module Monitoring Processor Performance

ECM internal error continues for 1 second (1 trip detection logic).

ECM

Comes on

DTC stored

P060B

Internal Control Module A/D Processing Performance

ECM internal error continues for 1 second (1 trip detection logic).

ECM

Comes on

DTC stored

P1607

Cruise Control Input Processor

ECM internal error continues for 1 second (1 trip detection logic).

ECM

Comes on

DTC stored

CONFIRMATION DRIVING PATTERN

DTC No.

DTC Detection Drive Pattern

P0606

Ignition switch ON for 1 second

P060A

P060B

P1607

CAUTION / NOTICE / HINT

Note:

After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE

  1. CHECK WHETHER DTC OUTPUT RECURS

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Clear the DTCs.

      Powertrain > Engine > Clear DTCs

    4. Turn the ignition switch off for 30 seconds or more.

    5. Turn the ignition switch to ON for 1 second.

    6. Enter the following menus: Powertrain / Engine / Trouble Codes.

      Powertrain > Engine > Trouble Codes

    7. Read the DTCs.

      Result

      Proceed to

      DTC P0606, P060A, P060B and/or P1607 is output

      DTC is not output
    DTC is not output

    CHECK FOR INTERMITTENT PROBLEMS

    Click here

    DTC P0606, P060A, P060B and/or P1607 is output

  2. REPLACE ECM

    1. Replace the ECM.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.

      Powertrain > Engine > Clear DTCs

    5. Turn the ignition switch off for 30 seconds or more.

    6. Turn the ignition switch to ON for 1 second.

    7. Enter the following menus: Powertrain / Engine / Trouble Codes.

      Powertrain > Engine > Trouble Codes

    8. Confirm that the DTC is not output again.

    Result

    Proceed to

    NEXT
    NEXT

    END