GENERATOR(for 130 A Type) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  4. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE V-RIBBED BELT

    Click here

  7. REMOVE GENERATOR ASSEMBLY

    1. A293795

      Remove the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the connector and detach the wire harness clamp.

    4. A296608

      Remove the 2 bolts and adjusting bar.

    5. A296609

      Remove the bolt and generator.

    6. A285298

      Remove the bolt and wire harness clamp bracket.