THEFT DETERRENT SYSTEM DATA LIST / ACTIVE TEST
DATA LIST
Tip:Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
According to the display on the GTS, read the Data List.
Body Electrical > Main Body > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Key Unlock Warning SW
Unlock warning switch*1
ON or OFF
ON: Key inserted into ignition key cylinder
OFF: Key removed from ignition key cylinder
-
ACC SW
Ignition switch
ON or OFF
ON: Ignition switch ACC
OFF: Ignition switch off
"ON" is also displayed for this item when the ignition switch is ON.
IG SW
Ignition switch
ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off or ACC
"OFF" is also displayed for this item when the ignition switch is ACC.
RR Door Courtesy SW
Rear door courtesy light switch RH
ON or OFF
ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW
Rear door courtesy light switch LH
ON or OFF
ON: Rear door LH open
OFF: Rear door LH closed
-
Back Door Courtesy SW
Back door courtesy light switch
ON or OFF
ON: Back door open
OFF: Back door closed
-
FR Door Lock Pos
Front door RH unlock detection switch
LOCK or UNLOCK
LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FR Door Courtesy SW
Front door courtesy light switch RH
ON or OFF
ON: Front door RH open
OFF: Front door RH closed
-
FL Door Lock Pos
Front door LH unlock detection switch
LOCK or UNLOCK
LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
FL Door Courtesy SW
Front door courtesy light switch LH
ON or OFF
ON: Front door LH open
OFF: Front door LH closed
-
Hood Courtesy SW
Engine hood courtesy switch
ON or OFF
ON: Engine hood open
OFF: Engine hood closed
-
RR-Door Lock Pos SW
LH and RH side rear door unlock detection switch signal
ON or OFF
ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked
-
RL-Door Lock Pos SW
LH and RH side rear door unlock detection switch signal
ON or OFF
ON: Rear door LH or RH unlocked
OFF: Rear door LH and RH locked
-
Intrusion Sens OFF SW
Intrusion sensor cancel switch*2
ON or OFF
ON: Intrusion sensor cancel switch on
OFF: Intrusion sensor cancel switch off
-
Intrusion Sensor
Status of the intrusion sensor detection*2
ON or OFF
ON: Intrusion sensor detected
OFF: Intrusion sensor not detected
-
Tilt Sensor
Status of the tilt sensor detection*3
ON or OFF
ON: Tilt sensor detected
OFF: Tilt sensor not detected
-
Intrusion Sen Conn
Intrusion sensor connecting*2
ON or OFF
ON: Intrusion sensor connected
OFF: Intrusion sensor not connected
-
Tilt Sensor Connect
Tilt sensor connecting*3
ON or OFF
ON: Tilt sensor connected
OFF: Tilt sensor not connected
-
Sealed Glas Brak Sen
Glass breakage sensor connecting*4
With or Without
With: Glass breakage sensor connected
Without: Glass breakage sensor not connected
-
Slide Roof Open Warning
This function is used to enable or disable the sliding roof open warning*5
ON or OFF
Customization status displayed
-
Warning by Horn
Function that allows vehicle horns and theft deterrent horn to be used as warning device*6
ON or OFF
Customization status displayed
-
Intrusion Win Opened
This function is used to enable or disable the window open warning
ON or OFF
Customization status displayed
-
Security control with mechanism key
This function makes it possible to cancel the security alarm with the mechanical key*7
ON or OFF
Customization status displayed
-
Intrusion Sensor Function
This function is used to enable or disable the intrusion sensor warning*8
ON or OFF
Customization status displayed
-
*: w/o Entry and Start System
*2: w/ Intrusion Sensor
*3: w/ Tilt Sensor
*4: w/ Glass Breakage Sensor
*5: w/ Sliding Roof System
*6: w/o Follow Me Home
*7: w/ Follow Me Home
*8: for Australia, New Zealand
ACTIVE TEST
Tip:Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body, Entry&Start*1 or Immobiliser*2 / Active Test.
*1: w/ Entry and Start System
*2: w/o Entry and Start System
According to the display on the GTS, perform the Active Test.
Body Electrical > Main Body > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Security Indicator
Security indicator*1
ON or OFF
-
Security Horn2
Theft warning siren*2
ON or OFF
-
Vehicle Horn
Vehicle horn
ON or OFF
-
Security Horn
Security horn*3
ON or OFF
-
Power For Intrusion Sensor
Intrusion sensor power supply*4
ON or OFF
-
Power For Tilt Sensor
Tilt sensor power supply*5
ON or OFF
-
*1: w/o Entry and Start System
*2: w/ Theft Warning Siren
*3: w/ Security Horn Assembly
*4: w/ Intrusion Sensor
*5: w/ Tilt Sensor
Body Electrical > Entry&Start > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Immobiliser Indicator
Security indicator*
ON or OFF
-
*: w/ Entry and Start System
Body Electrical > Immobiliser > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Security Indicator
Security indicator*
ON or OFF
-
*: w/o Entry and Start System