HEIGHT CONTROL SENSOR(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Note

Be sure to read the "PRECAUTION" thoroughly before servicing.

Click here

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED

    Click here

  2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B006CX4

      Disconnect the connector.

    2. B006E7PC01
      *a Matchmark

      Place matchmarks on the height control sensor link and load sensing valve sensor bracket.

      Tech Tips

      By placing a matchmark on the center link of the bracket, it can be installed by aligning the matchmarks. As a result, vehicle height adjustment can be performed with ease.

    3. Remove the nut and disconnect the height control sensor link from the load sensing valve sensor bracket.

    4. B006DHJ

      Remove the 2 bolts and rear height control sensor sub-assembly LH from the rear suspension member sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.

  3. REMOVE LOAD SENSING VALVE SENSOR BRACKET LH


    1. B006CM9

      Remove the bolt and load sensing valve sensor bracket from the No. 2 rear suspension arm LH.