STEERING COLUMN ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

  • If the power steering ECU assembly is subjected to an impact, replace it with a new one.

  • Do not pull the wire harness.

  • Do not allow any moisture to come into contact with the power steering ECU assembly.

  • Do not loosen any bolts not mentioned in the procedure.

  • Do not allow any foreign matter to contaminate the power steering ECU assembly.

PROCEDURE


  1. REMOVE STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY


    1. Secure the steering column assembly in a vise between aluminum plates and cloths.

      Note

      Do not overtighten the vise.

    2. Using a drill, drill a hole in the steering lock set bolt and insert a screw extractor.

    3. A01VUX0

      Using the screw extractor, remove the 2 steering lock set bolts and steering lock actuator or upper bracket assembly.

  2. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU


    1. A01VUVZC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the multiplex tilt and telescopic ECU.

  3. REMOVE POWER STEERING ECU ASSEMBLY

    Click here