REAR SPEED SENSOR INSTALLATION


  1. INSTALL REAR SPEED SENSOR


    1. Install the speed sensor RH with the bolt.

      A01DXPR
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

    2. Install the harness clamp with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Note


      • When installing the clamp, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    3. Attach the 2 clamps.

      Note

      When attaching the clamps, do not twist the wire harness.

    4. Attach the connector.

      Note


      • Securely attach the connector.

      • When attaching the connector, do not twist the wire harness.

    5. Connect the connector.

      Note


      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

    6. Install the speed sensor LH with the bolt.

      A01DZIJE01
      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the axle housing hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the axle housing.

    7. Install the 2 harness clamps with the 2 bolts.

      Torque:
      for bolt A
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }
      for bolt B
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Note


      • When installing the clamps, do not twist the wire harness.

      • Make sure the clamp rotation stopper touches the installation position.

    8. Attach the clamp.

      Note

      When attaching the clamp, do not twist the wire harness.

  2. INSTALL REAR WHEEL

    Torque:
    for Steel Wheel (2WD)
    152 N*m  { 1550 kgf*cm, 112 ft.*lbf }
    for Aluminum Wheel (2WD)
    121 N*m  { 1234 kgf*cm, 89 ft.*lbf }
    for 4WD and Pre-Runner
    105 N*m  { 1071 kgf*cm, 77 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SPEED SENSOR SIGNAL


    1. w/ ABS:

      Check the speed sensor signal Click here.

    2. w/ VSC:

      Check the speed sensor signal Click here.