AIR COOLED OIL COOLER INSTALLATION

PROCEDURE

  1. INSTALL OIL COOLER ASSEMBLY

    1. C278155N01

      Install the No. 1 oil cooler bracket with the 2 bolts. Tighten the bolts in the order shown in the illustration.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

    2. C302913N01

      Install the oil cooler assembly and No. 2 oil cooler bracket with the 4 bolts. Tighten the bolts in the order shown in the illustration.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

    3. C278526C01

      *a

      Yellow Paint Mark

      *b

      White Paint Mark

      *c

      Pink Paint Mark

      Connect the hose clamp and install the oil cooler hose assembly, and slide the clips to secure it.

      Note:

      • Make sure the paint marks are aligned as shown in the illustration.

      • Make sure that the claws marked A in the illustration are facing toward the front end of the vehicle.

      • Position the claws of the clips so that they do not interfere with other parts unless otherwise specified.

  2. INSTALL TRANSMISSION OIL COOLER AIR DUCT

    1. C302914C01

      *a

      Rib

      Attach the rib of the transmission oil cooler air duct, and then temporarily install the oil cooler assembly with the 2 bolts.

    2. Tighten the 2 bolts.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

  3. INSTALL OIL COOLER TUBE SUB-ASSEMBLY

    1. C278139C01

      *1

      Pin

      Install the oil cooler tube sub-assembly with the 2 bolts. Tighten the bolts in the order shown in the illustration.

      5.5 N*m

      56 kgf*cm

      49 in.*lbf

      Note:

      Insert the pin of the radiator fan shroud into the hole of the oil cooler tube sub-assembly.

    2. C278530C01

      *a

      Upper View

      *b

      Yellow Paint Mark

      *c

      Green Paint Mark

      Install the No. 1 oil cooler inlet hose, No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose, and slide the clips to secure it.

      Note:

      • Make sure that the paint marks are in the position shown in the illustration.

      • Make sure that the claws marked A in the illustration are facing toward the front end of the vehicle, and that the claws marked B in the illustration are facing toward the underside of the vehicle.

      • Position the claws of the clips so that they do not interfere with other parts unless otherwise specified.

  4. ADD AUTOMATIC TRANSAXLE FLUID

    Click hereClick here

  5. ADJUST AUTOMATIC TRANSAXLE FLUID

    Click hereClick here

  6. INSTALL FRONT BUMPER COVER

    Click hereClick here

  7. INSTALL REAR ENGINE UNDER COVER LH

    Click hereClick here

  8. INSTALL NO. 1 ENGINE UNDER COVER

    Click hereClick here