CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the auxiliary battery negative (-) terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system..

    3. Clean any remaining adhesive from the bolt holes for the curtain shield airbag assembly in the vehicle body.

    4. Temporarily install the curtain shield airbag assembly LH with 2 new bolts and attach the 2 claws (A).

      Note:

      Do not twist the curtain shield airbag assembly when installing it.

    5. Install the 2 bolts.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

    6. Attach the 2 claws (B).

    7. Install 7 new clips and then push in the 7 pins.

      B339314C01

      *1

      Bolt

      *2

      Claw (A)

      *3

      Claw (B)

      *4

      Clip

      *5

      Pin

      -

      -
    8. B339312C01

      *1

      Connector Lock

      Connect the curtain shield airbag connector.

      Note:

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    9. Push in the connector lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick here

  4. INSTALL BATTERY SERVICE COVER

    Click here

  5. INSTALL DECK BOARD ASSEMBLY

    Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  7. CHECK SRS WARNING LIGHT

    Click here