HEADLIGHT ASSEMBLY(for Triple Beam Headlight) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL HEADLIGHT ASSEMBLY LH


    1. B008JMIC01
      *a Connector Lock Lever
      B008IUL Connect the Seat of the Screw

      Connect the connector and lock the connector lock lever.

    2. Attach the guide to set the headlight assembly LH.

    3. Connect the seat of the screw at the location indicated by the black arrow shown in the illustration and set the headlight assembly LH in place.

    4. Install the bolt and 3 screws.

      Torque:
      for Bolt
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  2. INSTALL FRONT BUMPER ASSEMBLY

    except Sport Package:

    Click here

    for Sport Package:

    Click here

  3. PERFORM INITIALIZATION (When Replacing The Headlight Assembly LH or Headlight Light Control ECU Sub-assembly LH)

    Note


    • If any of the work in the table below has been performed, vehicle information registration and initialization of the headlight light control ECU sub-assembly LH is necessary.

      Click here

      Performed Work or System Condition Necessary Procedures
      Replacement of the headlight light control ECU sub-assembly LH Vehicle information registration for the headlight light control ECU sub-assembly LH
      Initialization of the headlight light control ECU sub-assembly LH
      Replacement of the headlight assembly LH Vehicle information registration for the headlight light control ECU sub-assembly LH
      Initialization of the headlight light control ECU sub-assembly LH

    • A new headlight light control ECU sub-assembly LH cannot operate until the vehicle information is registered.

    • After replacing the headlight light control ECU sub-assembly LH, it is necessary to register the vehicle information and then perform initialization.

    • Even if the headlight light control ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

    • Vehicle information registration must be performed with the multiplex network body ECU (main body ECU) and hybrid vehicle control ECU connected via CAN communication.

  4. ADJUST HEADLIGHT AIMING

    Click here