FRONT DIFFERENTIAL OIL SEAL(for LH Side) REPLACEMENT

PROCEDURE

  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  3. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    1. C242832

      Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.

    2. C279062C05

      *1

      No. 1 Transmission Oil Filler Tube

      Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the continuously variable transaxle assembly and drain the continuously variable transaxle fluid.

    3. Using a 6 mm socket hexagon wrench, install the No. 1 transmission oil filler tube to the continuously variable transaxle assembly.

      1.7 N*m

      17 kgf*cm

      15 in.*lbf

    4. Temporarily install the gasket and overflow plug.

      Tip:

      Reuse the old gasket. The plug will be removed again to adjust the fluid level.

  4. REMOVE FRONT DRIVE SHAFT ASSEMBLY

    Click here

  5. REMOVE CVT TYPE T OIL SEAL LH

    1. C103977E03

      Using SST, remove the CVT type T oil seal LH from the transaxle case.

      09308-00010

      Note:

      Do not damage the transaxle case.

  6. INSTALL CVT TYPE T OIL SEAL LH

    C279203E04

    1. Using SST and a hammer, tap in a new CVT type T oil seal LH to the transaxle case.

      09316-10010

      09950-70010

      09951-07200

      Standard depth

      -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

      Note:

      Do not damage the lip of the CVT type T oil seal LH.

    2. Coat the lip of the CVT type T oil seal LH with MP grease.

  7. INSTALL FRONT DRIVE SHAFT ASSEMBLY

    Click here

  8. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  9. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  10. INSTALL NO. 1 ENGINE UNDER COVER

    Click here