TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on

Click here

Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.

Replacement of ECM

(If possible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Transfer transaxle compensation code

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • Deterioration of fuel efficiency

Click here for UB80E Initialization

Click here for UB80E Registration

Replacement of ECM

(If impossible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn
Replacement of ECM Perform code registration (Immobiliser function)

  • Wireless door lock control system

  • Smart Entry and Start System (for Entry Function)

  • Smart Entry and Start System (for Start Function)

  • Steering lock function

 See Service Bulletin for the registration method.
*1: When the ECM is replaced with a new one, reset memory is unnecessary.

PROCEDURE


  1. REMOVE BATTERY

    Click here

  2. REMOVE ECM

    Click here

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  5. REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR


    1. B0084G6

      Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.

  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

    Click here

  7. REMOVE NO. 1 CONSOLE BOX DUCT


    1. B0087DM

      Remove the No. 1 console box duct.

  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. B0086JTC01
      *a Clip
      *b 45° to 60°

      While disengaging the clip as shown in the illustration, disconnect the transmission control cable assembly from the transmission control shaft lever together with the clip.

    2. B0088RF

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. B0083HP

      Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.

    4. B0085IU

      Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.