STEERING ANGLE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during steering sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of steering sensor

  • Steering angle neutral point (Initialize parking assist monitor system)

  • Steering angle setting

 Parking assist monitor system

Click here for Initialization

Click here for Calibration

PROCEDURE


  1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  2. REMOVE STEERING SENSOR


    1. B0085SA

      Disengage the 6 claws and 2 pins, and remove the steering sensor from the spiral cable sub-assembly.

      Note

      Do not damage the claws and pins of the spiral cable sub-assembly.