РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с 1GR-FE) ПОВТОРНАЯ СБОРКА


  1. INSTALL RELEASE CYLINDER BLEEDER PLUG

    Torque:
    11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  2. INSTALL CLUTCH RELEASE CYLINDER KIT


    1. Install the bleeder plug cap to the bleeder plug.

    2. Install a new spring to the cylinder body.

    3. A01DXRVE01

      Apply lithium soap base glycol grease to the areas indicated by the arrows in the illustration.

    4. Install the piston to the cylinder body.

      Note

      Be careful not to damage the inside of the cylinder body.

    5. Install the push rod to the boot.

    6. Install the boot (with push rod) to the cylinder body.