PERSONAL LIGHT INSPECTION

PROCEDURE

  1. INSPECT MAP LIGHT ASSEMBLY

    1. E262978C03

      *A

      w/ Room Light (for Push Switch Type)

      *a

      Component without harness connected

      (Map Light Assembly)

      Inspect the personal lights.

      1. Apply battery voltage to the each terminal of map light assembly connector and check the operation of the personal lights.

        Result

        Connection

        Condition

        Specified Condition

        Battery positive (+) → 8 (+B1)

        Battery negative (-) → 11 (GND)

        Personal light switches off and interior light door switch off

        Personal light LH and RH do not come on

        Personal light switch LH on

        Personal light LH comes on

        Personal light switch RH on

        Personal light RH comes on

        Battery positive (+) → 8 (+B1)

        Battery negative (-) → 3 (CTY)

        Personal light switches off and interior light door switch off

        Personal light LH and RH do not come on

        Personal light switches off and interior light door switch DOOR

        Personal light LH and RH come on

        If the result is not as specified, replace the bulb or map light assembly.

    2. w/ Room Light (for Push Switch Type):

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        7 (RRMP) - 3 (CTY)

        Interior light door switch off

        10 kΩ or higher

        7 (RRMP) - 3 (CTY)

        Interior light door switch DOOR

        Below 1 Ω

        If the result is not as specified, replace the map light assembly.