CYLINDER BLOCK(w/o Glow Plug Controller) REPLACEMENT

PROCEDURE

  1. REPLACE STRAIGHT PIN

    1. Remove the 9 straight pins shown in the illustration from the cylinder block sub-assembly.

    2. Using a plastic-faced hammer, tap in 9 new straight pins.

      A286935C01

      *a

      Front Side

      *b

      Upper Side

      *c

      Rear Side

      *d

      Lower Side

      *e

      LH Side

      -

      -

  2. REPLACE STUD BOLT

    1. Using an E6 "TORX" socket wrench, remove the 2 stud bolts.

    2. A198474

      Using an E6 "TORX" socket wrench, install the 2 stud bolts.

      6.0 N*m

      61 kgf*cm

      53 in.*lbf